FREQUENTLY ASKED QUESTIONS

MY CABLE IS WEARING:

GENERAL MAINTENANCE

CHECK PULLEYS, THEY SHOULD TURN FREELY

THE U-BOLT BELOW THE WINCH MUST NOT BE OVER TIGHTENED, THE PULLEY NEEDS TO SWING FREELY ON THE U-

BOLT. ONLY 1-2 THREADS SHOULD BE EXPOSED BEHIND THE NUTS.

MY PULLEYS ARE NOT TURNING OR ARE NOT TURNING EVENLY:

GENERAL MAINTENANCE – BECAUSE OF THE DIFFERENT MINERAL CONTENTS OF YOU WATER, OVER TIME THE

BEARINGS MAY CORRODE AND THE PULLEY INSERT WILL NEED TO BE REPLACED.

MY WINCH STICKS, THE LIFT WON’T STAY UP OR IT IS HARD TO LOWER:

REMOVE WHEEL AND CLEAN THREADS ON WHEEL AND SHAFT; LUBRICATE SHAFT MAKING SURE TO KEEP THE

CLUTCH DISC LUBRICANT FREE, REPLACE WHEEL.

CAN I REVERSE MY WINCH:

YES, SEE “REVERSE WINCH” IN THE OWNER’S MANUAL, REMEMBER TO CHANGE THE BED CABLE. THE CABLE

MUST START IN THE CORNER WITH THE WINCH AND TRAVEL TO THE OPPOSITE CORNER.

MY BED IS NOT LEVEL WHEN IT RAISES:

CHECK ROLLERS TO MAKE SURE THEY ARE TURNING FREELY

CHECK PULLEYS TO MAKE SURE THEY ARE TURNING FREELY

CHECK TO SEE THAT THE BED CABLE HAS BEEN INSTALLED PROPERLY

CAN I RELEASE TO CLICKER STOP MANUALLY TO LET THE LIFT FREE FALL?

NO!! THE WHEEL SHOULD NOT FREE SPIN. NEVER STICK HANDS THROUGH OR BEHIND WHEEL

. NEVER RELEASE CLICKER STOP MANUALLY. INJURY MAY RESULT.

MY CABLE IS RUBBING ON THE SIDE OF THE PULLEY THAT IS UNDER THE WINCH,

 THE CABLE BUILDS UP ON ONE SIDE OF THE WINCH SPOOL CAUSING THE CABLE TO JUMP:

YOUR SIDEFRAME U-BOLT HAS BEEN OVERTIGHTENED. LOOSEN THE U-BOLT UNTIL 1-2 THREADS ARE EXPOSED BEHIND THE NUTS.

©2017 Harbor Master

Website Designed by Tyler Stowell

CONNECT WITH US